Flowmeters and System Solutions

Flowmeters and System solution.

MENU

PRODUCTS

CONTACT-CLOSURE PULSE GENERATOR

Format:PG20EP

Liquid

Gas

Steam

接点パルス発信器_容積流量計

接点パルス発信器_容積流量計

This pulse generator is designed to mount on an OVAL flowmeter. The flowmeter,s rotor revolution proportional to the rate of flow is transmitted through a conversion gear train to a permanent magnet which in turn drives a reed switch, Whereby a contact-closure pulse train proportional to the flow rate is generated. This pulse generator is used only for factored pulse generation.

  • explosionproof
Features
Product Specifications
Document

Applicable fluid

water

kerosene

light oil

GENERAL SPECIFICATIONS

Model PG20EP
PG21EP PG22EP
No. of Pulses per One
Pointer Revolution
1P/rev 10P/rev
Conversion Gear Ratio 1/2 5/1
Principle of Signal
Generation
Contact-closure pulses generated by a per-manentmagnet
driven reed switch
Drive Magnet Material & Property BF, Anisotropic
Dimensions 8×5×4 mm
Magnetic Flux
Density
1100 to 1300G
Duty Factor ON/OFF=1/1 to 1.8/1
Operating Temp. Range −20℃ to +90℃
Finish Munsell 2.5G 8/2
Reed Switch Assy. Part No. RS−0−13
Test Volt.
across Contact
125VAC, 50VDC
Current Capacity 60mA
Contact Bounce Bounce time: Max. 0.5ms
Life 10 million Pulses (at 5VA, 60mA Resistance load)
2000 million Pulses (at 12VDC, 5mA Resistance load)
Contact Protection w/Surge suppressor and Spark killer.
Finish Black
Construction Explosion-proof
Construction
Flame-proof
Explosion-proof
Performance
d2G4
Conduit Connection Rc 3/4
Starting Torque 25 g•cm Max. at gear ratio 5 to 1
Suggested Cable 2-conductor shielded control cable having
a conductor area 1.25mm2 to 2.0mm2.
Maximum signal cable length 1 km.
Shielded cable is suggested only where
stray current induction is anticipated;
otherwise 2-conductor control cable will do.
Mass(approx.) 2.1kg

Specification

*You need to fill out the questionnaire to download documents.

GBC901E-7

PG20, PG20EP

Features
Product Specifications
Document
Back

INQUIRY

INQUIRY